How To Install The Dual Steering Stabilizer Kit On Dodge Ram 2500

0
97

Editor’s Note: This install guide is kindly shared by a young Youtuber The Buckaroos. He installed the MaXpeedingRods Dual Steering Stabilizer on his 2010 Dodge Ram 2500. The install instruction can be applied to a Ram 2500 of the year 2003 to 2013, and a Ram 3500 of the year 2003 to 2012.

What does the dual steering stabilizer kit cover?

Bracket 1: one
Damping components: 2
Flat pad M12: 14
Hexagonal nylon locknut M12*1.5: 7
Hexagon head bolt M12*1.5*75-35: 5
Side seat: 1
Gasket: 1
U-shaped card M10*1.5*32-51*73: 2
Bracket-A:1
Hexagon head bolt M10*1.5*45: 2
Hexagon head bolt M12*1.5*45: 2
Flat pad M10: 2
Bracket 2: 1
Hexagonal nylon locknut M10*1.5: 2

What to install the dual steering stabilizer kit?

Step 1: Loosen the stabilizer bolts on the left and right sides, and remove the stabilizer on the original car.
Step 2: Install bracket 1 and bracket 2 on the left and right sides respectively.

Step 3: Install the damping component and bracket 1 and bracket 2 respectively.
Step 4: Install the U-shaped card and bracket A in the middle of the car connecting rod.
Step 5: Install the bottom of the two damping kits with the side seat and bracket A, shown in the picture below.

Step 6: Finally tighten all the bolts on both sides and in the middle.

There is nothing difficult about the install instruction of the dual steering stabilizer kit. While installing, make sure that all the bolts are tightened to avoid any damage during driving. MaXpeedingRods is not responsible for any loss caused by improper operation.

LEAVE A REPLY

Please enter your comment!
Please enter your name here